Dipl.-Ing. H. Horstmann GmbH
Instructions for Use
14
SMART
NAVIGATOR
3.5
SMART
NAVIGATOR
@S
MART RECEIVER
R
EGISTRATION
P
ROCEDURE
The registration of other end devices like a SMART CONTROLLER embedded in an RTU might differ
in registration steps, please refer to the specific end devices user manual.
Before a SMART NAVIGATOR can transmit data to a SMART RECEIVER it has to initially once
register at and with the SMART RECEIVER. If registration was successful and the SMART
RECEIVER looses power supply the registration data remains safe and communication ability
recovers after the power returns. Please refer to communications section. The registration requires 4
steps as follows:
Step 1
Confirm that the SMART NAVIGATOR is NOT flashing and that the SMART RECEIVER is powered
(“ON” LED is active).
Step 2
Hold a magnet close to the reed switch until TX and I/O LEDs light up. This may take up to 10
seconds. A time window of 3 minutes is now open for pairing with a SMART NAVIGATOR.
Step 3
Hold the magnet close to the RESET point of the SMART NAVIGATOR until a yellow LED in the
SMART NAVIGATOR lights up twice. If after a maximum of 10 seconds either a red LED or no LED
has flashed at all, the registration procedure has failed (Please retry in such case).
For an overview about the meaning of the SMART NAVIGATOR LEDs refer to the following table:
Step 4
Check that the SMART RECEIVER has turned off the I/O and TX LEDs. This means that the SMART
RECEIVER completed the registration procedure successfully, too.
If this does not happen, press the push button for about 1 second and start from step 1.
Step 5 (Optional)
Repeat steps 1-4 in order to register up to 12 SMART NAVIGATORs per SMART RECEIVER.
Yellow LED flashing twice
SMART NAVIGATOR completed registration successfully
Red LED flashing twice
Communication Error
Repeat procedure from step 1
12 SMART NAVIGATORs already registered with SMART RECEIVER
Check installation plan
No LED flashing
SMART RECEIVER not in registration mode
Check TX and I/O LED are active
Repeat
procedure from step 1
Either device defect
Return for repair
