diono.com
radian 3QX
34
35
REAR
–
FA
CING
REAR
–
FA
CING
3. Place car seat rear-facing in
back seat of the vehicle with
detachable rear-facing base
installed (page 33).
Center the
car seat between the vehicle
LATCH/UAS anchors. The entire
seat bottom should sit flat on
the vehicle seat.
4. Slide the LATCH/UAS strap
through the rear-facing belt
path and out the other side.
The LATCH/UAS strap should
lie flat and not be twisted.
5. Attach LATCH/UAS connectors
to vehicle LATCH/UAS anchors
and listen for audible "click" to
confirm engagement.
3
4
5
6. Tighten the LATCH/UAS strap.
Press down firmly in the center
of the car seat while tightening
the LATCH/UAS strap. You
may need to tighten further by
pulling upwards in-line with
the belt path as shown.
7. Test for tightness.
Grab the side of the seat with
one hand where the LATCH/
UAS strap is and slide the car
seat side-to-side and front-
to-back. If the seat moves
less than 1 in. (2.5 cm), it is
tight enough. Do not test by
grasping the top or back of the
seat.
8. To remove LATCH/UAS strap
from vehicle
— Use LATCH/
UAS release on the LATCH/
UAS connectors and pull them
off the anchor bars.
7
6
8