Dionex ASE 150, Руководство оператора

Страница: 121 / 176

B • Installation
Doc. 065207-02 9/08
113
B.2.6 Connecting the Solvent Reservoir
1. If you plan to run a preprogrammed method, refer to Section 2.5 for
the recommended solvent. If you plan to run a custom method, review
the solvent selection guidelines in
Section 3.1.1 .
2. Fill the solvent reservoir with prepared solvent to the level indicated
in Figure B-5 .
NOTE The solvent level in the reservoir must remain
below the gas inlet line, to prevent solvent from
coming into contact with the pneumatic valves.
3. Place the solvent reservoir in the recess on top of the ASE 150.
4. Insert the solvent outlet line extending from the underside of the cap
assembly (P/N 051977) into the solvent reservoir (see Figure B-5 ).
Make sure the end-line filter rests on the bottom of the bottle.
Use only Dionex solvent reservoirs. These are glass bottles with a
plastic, shatterproof coating. To prevent personal injury, make sure
the pressure applied to the bottles does not exceed 0.07 MPa (10 psi).
Utilisez uniquement des réservoirs à solvant Dionex. Ce sont des
réservoirs en verre à revêtement incassable en plastique. Veillez à ce
que la pression exercée sur ces réservoirs ne dépasse pas 0,07 MPa.
Verwenden Sie ausschließlich die Lösemittelbehälter von Dionex.
Dabei handelt es sich um Glasbehälter mit einer splittersicheren
Plastikbeschichtung. Vergewissern Sie sich, daß der Druck, der auf
die Behälter ausgeübt wird, 0,07 MPa nicht übersteigt.
Never fill the solvent reservoir or disconnect the tubing connections
to the solvent and gas connectors during a run or rinse cycle. At these
times, the solvent reservoir is pressurized. If you remove the bottle
cap when the solvent reservoir is pressurized, the ASE 150 may not
operate to specification.