4 OF 6
IG102918-6.0
HYDROLUME
®
INSTALLATION GUIDE
MOUNT HYDROLUME TO SURFACE.
See mounting options a, b & c (below).
Mark placement for HYDROLUME Mounting Brackets -- roughly
12 inches apart. Fasten brackets with M2.9 (#4) screw or similar
size (not provided). Once mounted, fasten HYDROLUME to
brackets.
a
HYDROLUME Mounting Brackets
Slide bracket into stake at desired angle to position HYDROLUME
strip. Press stakes into ground roughly 12 - 16 inches apart. Once
stakes are planted into ground, firmly press HYDROLUME strip
light into brackets.
Mount channel to desired surface using minimum 2x M2.9 (#4)
screws or a similar size (not provided). Once channel is mounted,
firmly press HYDROLUME into channel pressing one end to the
other.
b
c
C
Install Garden Stake
B
A
31-41cm
12”-16”
C
Install Garden Stake
B
A
31-41cm
12”-16”
C
Install Garden Stake
B
A
31-41cm
12”-16”
HYDROLUME Stake Brackets
HYDROLUME Mounting Channel
INSTALLATION (CONT.)
7
8
ATTACH CONTROL AND DRIVER
Verify a compatible driver is installed (refer to Specification Sheet).
Utilize applicable wiring when installing outdoors. (
Use of wet location
rated junction box recommended)
REVIEW SYSTEM
Ensure all polarities are correct and connections are secured.
TURN POWER ON AT CIRCUIT BREAKER
Shift in brightness
and/or kelvin
• Ensure applicable AWG (gauge) is installed
between strip light and LED driver.
See
VOLTAGE DROP CHARTS.
Some LEDs are not
functional
• Ensure strip light has not been bent
excessively, which could damage circuitry.
Lights are
flickering
• Ensure strip light has not been bent
excessively, which could damage circuitry.
• Ensure strip light has not been submerged
in any liquid for any amount of time.
Lights are turning
on/off repeatedly
• Ensure driver is not overloaded. An
overloaded driver will trip the internal
auto-reset (of driver) repeatedly, turning
the system on/off.
9
10