1 OF 6
IG102918-6.0
HYDROLUME
®
INSTALLATION GUIDE
®
INSTALLATION GUIDE
HYDROLUME
®
LED STRIP LIGHT
DRY/WET LOCATION
SALTWATER
RESISTANT
UV RESISTANT
DIMMABLE
24VDC
IP65
Input
24VDC Constant Voltage
Power
Standard
1.13W/ft. (0.65W/cut point)
Plus
2.04W/ft. (1.2W/cut point)
Max Run
Standard
81.5 ft.
Plus
32.6 ft.
Ambient Temp †
-4° ~ 122°F (-20° ~ 50°C)
1. Install in accordance with national and local electrical code regulations.
2.
This product is intended to be installed and serviced by a qualified,
licensed electrician.
3. Do not modify or disassemble this product beyond instructions or the
warranty will be void.
4.
Do not submerge, or install within 5 feet of a swimming pool.
5.
All plastics are affected by the elements and may shift in color and
other properties after product installation, particularly with direct
exposure to sun, chlorinated water, and other chemicals.
6. Only install with a Listed Class 2 DC LED driver.
7.
To avoid Voltage Drop, ensure wire gauge used with LED Strip Light is
sufficient to keep under 3% voltage drop.
8.
Do not exceed maximum run recommended for Strip Light.
9.
Diode LED Strip Light is designed to be cut at designated cut points
only. Cutting anywhere other than the cut points will result in damage
to the Strip Light.
10.
Failure to follow safety warnings, and installation instructions will void
the warranty for this product.
SAFETY & WARNINGS
QUICK SPECS / MODELS
ADDITIONAL ACCESSORIES
Mounting Bracket
DI-HL-MTBR
DI-24V-HL**
DI-24V-HLP**
** Indicates model and CCT
† Do not install product in environment outside listed temperature.
Stake Bracket
DI-HL-STBR
Mounting Channel
DI-HL-MTCH
DO NOT BEND LED STRIP
LIGHT TO A DIAMETER LESS
THAN 4 INCHES.
4 in.
DO NOT FOLD, CREASE, OR
TWIST LED STRIP LIGHT.
DO NOT BEND LED STRIP LIGHT
ON A HORIZONTAL PLANE.
DO NOT
POWER STRIP
LIGHT WHILE ATTACHED TO
SPOOL OR TIGHTLY COILED.
DO NOT COVER STRIP LIGHT WITH
ANY MATERIALS.
HANDLE PRODUCT WITH CARE!
CONNECTOR COMPRESSION
HYDROLUME Connectors may become compressed during shipping.
To decompress, insert flathead screwdriver under top of connector
and apply upward pressure until pins are completely removed from
opening.
