2 OF 6
IG102918-6.0
HYDROLUME
®
INSTALLATION GUIDE
INSTALLATION
1
TURN POWER OFF AT CIRCUIT BREAKER
2
SHOCK HAZARD!
May result in serious injury or death.
Turn power OFF at circuit breaker prior to installalation.
DETERMINE LOCATION TO INSTALL COMPONENTS
AC IN
DC OUT
L
G
N
V
−
V+
+
−
1) Class 2 Driver
2) Control
3) Hydrolume
*NOT FOR USE IN SUBMERSIBLE APPLICATIONS, OR WITHIN 5
FEET OF A SWIMMING POOL.
WIRE GAUGE & VOLTAGE DROP
Ensure applicable wire is installed between driver, fixture, and any
controls in between. When choosing wire, factor in voltage drop,
amperage rating, and type (in-wall rated, wet location rated, etc.)
CREATE HYDROLUME STRIP LIGHT SPLICE
CONNECTORS
4
Using a pair of scissors, cut one end off a Hydrolume Flexible
Extension Cable.
a
CUT END OFF OF FLEXIBLE EXTENSION
b
Using a pair of wire strippers, remove outer insulation and strip
back wires inside HYDROLUME Flexible Extension Cable.
c
Using the newly created Splice Connector, wire power supply to
end of HYDROLUME LED Strip Light.
Note: For detailed installation information, refer to the System Diagrams
on page 4.
(Use of wet location rated junction box recommended)
STRIP WIRES FROM END OF CONNECTOR
CONNECT TO A POWER SUPPLY
CREATE LENGTHS OF HYDROLUME STRIP LIGHT
3
Using a pair of scissors, cut HYDROLUME LED Strip Light at cut
point between arrows.
Refer to
SYSTEM DIAGRAMS
G*
N
L
V+
V
−
Class 2 Low Voltage Driver
Installed in Wet Location Junction Box
L
N
INPUT
OUTPUT
