7 OF 8
IG121620-3.0
AlphaTECH
®
LED Strip Light
INSTALLATION GUIDE
AlphaTECH
®
LED STRIP LIGHT
INSTALLATION GUIDE
The following diagrams are provided as example system designs. For information regarding larger systems or systems not
pictured below, please see our web page or contact technical support. Always review each component installation guide for
detailed and up-to-date wiring instructions. Install in accordance with national and local electrical codes.
L
N
G*
N
L
V+
V
−
120VAC On/Off Switch
Class 2 Low Voltage Driver
2
Installed in Junction Box
7
V+
V-
LED Tape Light / Fixture
8
Install appr
opriate wir
e gauge / type
V+
V-
AC Power
50/60Hz
INPUT
OUTPUT
Traditional ON/OFF Switch System
AC Power
50/60Hz
Compatible Dimming Control
or On/Off Switch
5
LED Tape Light / Fixture
8
L
Install appr
opriate wir
e gauge / type
OMNIDRIVE
®
Dimmable Driver
6
Some dimmers may require an
additional neutral wire connection.
N
N
GND*
N
L
V+
V−
V+
V−
V+
V−
INPUT
OUTPUT
Class 2 Low Voltage Driver
2
Installed in Junction Box
7
REIGN
®
24V Dimmer System
OMNIDRIVE
®
Electronic Dimmable Driver
System
SWITCHEX
®
Dimmer/Driver System
G*
N
L
V+
V
−
Class 2 Low Voltage Driver
3
Installed in Junction Box
7
V- (Black)
Input
Output
V+ (Red)
Install appr
opriate wir
e gauge / type
V+
V-
LED Tape Light / Fixture
8
REIGN 12-24V Dimmer
4
V+
V-
L
N
AC Power
50/60Hz
INPUT
OUTPUT
1. Driver may not require a fault ground connection. Refer to driver specifications for additional information.
2. Install a compatible Class 2 constant voltage driver. Refer to each driver specification sheet for full power ratings & load deratings.
3. Install a Class 2 constant voltage driver compatible with a low voltage PWM controller/dimmer switch. Refer to each driver specification sheet for full power
ratings & load deratings.
4. Determine the number of low voltage outputs of the driver when installing multiple PWM controllers/dimmer switches. No more than one PWM controller/dimmer
switch can be attached to a single output of the driver.
5. Install a compatible dimming control or switch. See the ‘Electronic Dimmable Driver / Dimmer Compatibility List’ for compatible dimming controls. See the
dimming control manufacturer installation guide for complete wiring instructions.
6. Ensure to load the driver at least 60% of the labeled load for proper dimming performance (required for dimmable installations only).
7. Refer to driver or controller specifications for a compatible junction box.
8. See fixture specifications for maximum series run limits.
N (WHT)
120 VAC
~ 60Hz
V+ (RED)
V
−
(BLUE)
+
−
+
−
L (BLK)
SWITCHEX
( Driver)
LED ARRAY / FIXTURE
Ground (GRN)
Ins
tall applic
able wire gauge / type
Ins
tall applic
able wire gauge / type
SYSTEM DIAGRAMS
