3 Configurations on Web Interface
SBC3000 Session Border Controller
Copyright©2011-2018 Dinstar
56
Figure 3-40 Configure Port Mapping
Table 3-31Port Mapping
Name
The name of this port mapping
Status
To enable or disable
Local Interface
The mapped interface of the SBC3000 device in local-area network
Local Port
Number
The mapped port of the SBC3000 device in local-area network (this port cannot
conflict with the in-use port of the SBC3000 device )
Transport
Protocol
Choose TCP, UDP or TCP\UDP
Remote
Interface
The interface of the client in the wide-area network, which is to visit the
SBC3000 device in local-area network1
Remote Port
Number
The port of the client in the wide-area network, which is to visit the SBC3000
device in local-area network
Remote IP
Address
The IP address of the client in the wide-area network, which is to visit the
SBC3000 device in the local-area network.
Static Route
On the
System
Static Route
interface, you can configure static routes for the network. After a static route is
successfully set, related packets will be sent to the designated destination according to the static route. Click
to enter into the setting page of static route.
