Dinghua DH-G200, Руководство пользователя

Страница: 16 / 28

16
图
9
Click , the machine will be in the heating condition The running data is just the above
current parameters Meanwhile, it helps eliminate the displayed curve last time In the normal condition, it
means the heating process is finished when the temperature speed is zero during the whole running
process And then the machine will stop and inform you through the alarm
During the working process, click , it will stop heating directly, when
click OFF, the button will flash, indicates that the machine goes into constant state,
three group of heating output of the whole machine will operate with current temperature, until click
OFF again, the machine come back the normal heating state
setting has been done with all parameters set when the machine leaves factory, users have no need to
modify
This machine can log monitor rotate speed of cooling fan against hot wind from up and down, and
you can also set the lowest rotate speed When it appears that fan stops or fan rotate speed lower than it
is set during heating, when the upper and bottom temperature higher than 300 degrees, the system will
stop heating, system can set advance roar automatically say 10s,
when it is 10s before the machine finishing heating, the buzzer will roar
The complete machine switch to cooling state, and display relevant fault point tips on the Lord working