Dinghua DH-5830, Руководство пользователя

Страница: 18 / 20

18
Above is lead-free type BGA reference temperature
When remove the BGA chip, the temperutre reduction is set at 0.
八 、
Handling Precautions
1. After opening the power, firstly you should check whether the upper and bottom hot air nozzles
have cold wind.If not, starting the power is strictly prohibited.or the heaters will be burnt.The
bottom infrared heating areas are all controlled by switch, and you can choose the bottom heating
areas depend on the PCB
board size.
2. You should set different temperature curves when repair different BGA,each temperature
should not higher than 300
℃；
Lead-free rework setting can refer to welding temperature curve of
BGA tin bead.
3. When demount BGA,the cooling fan and vacuum should be setted to automatic
transmission,the buzzer will warn automatically when temperature curve runs to the
end.Meanwhile, remove the BGA from PCB board with vacuum pen, and then remove the PCB
board from the positioning frame.
4.When welding the BGA chip,set the cooling fan to manual grade
、
close vaccum.After the
temperature curve runs to the end, the buzzer will alarm automatically,the cooling fan begins to
cooling the BGA chip and bottom heating zone,meanwhile,the warm heating head will blow a
cold wind.Then elevate the upper heater,make the gap has 3-5mm space between the bottom of
nozzle and the upper surface of BGA chipand keep cooling for 30-40 seconds,or move away the
main heater after the starting light is off,finally take away the PCB boaed from the support.
5. Before installation of BGA chip, it is necessary to check that if the PCB pad and BGA tin bead
are all in good condition.After welding, it have to check the exterior appearance by piece, if it is
unusual, it should stop the BGA chip installation and test the temperature, and it has to be adjusted
Preheating Constant Heating
Welding
1st
Welding
2nd
Reduction
Upper
heating
165 190 220 240 245 235
Constant
time
30 30 35 40 20 15
Bottom
heating
165 190 220 240 245 235
Constant
time
30 30 35 40 20 15
IR
preheating
180 0 0 0 0 0
Constant
time
300 0 0 0 0 0
Speed rate 3 0 0 0 0 0