19
©
Dinel, s.r.o. PDU–4xx–W
“AddP”, ”dELP”
and
“EdtP”
options are available only if the user defined characteristic is
used (it means when parameter
“CHAr” = ”USEr”
).
•
"EdtP"
This option allows user to modify of particular point of the user defined characteristic.
After selection current number of points of the user defined characteristic is displayed for
about approx. 1.5 sec. After that device waits for selection of point being edited (by
[^]
,
[v]
buttons). The short pressing of
[ENTER]
button causes by switching between X and
Y value of the displayed point. The long press (press and hold at least 2 sec) of
[ENTER]
button causes by entering to edit the selected coordinate of the point. Modification of the
coordinates is done accordingly to numerical parameters edition.
•
User can not enter two points with the same value of
„X”
coordinate. If user trays to do it,
”Err”
warning is displayed. To modify any defined point use
”EdtP”
option.
•
To distinguish
„X”
and
„Y”
coordinates, if „
X”
coordinate is displayed an additional decimal
point on utmost right position is displayed.
•
If user defined characteristic is selected, and if number of defined points is lowerthan 2 then
warning
”Errc”
is displayed in measurement mode.
•
"dELP"
This option allows user to delete any of the points of the user defined characteristic. After
selection current number of points of the user defined characteristic is displayed for about
approx. 1.5 sec. After that device waits for selection of point being deleted (by
[^], [v]
buttons). The short pressing of
[ENTER]
button causes by switching between X and Y
value of the displayed point. The long press (press and hold at least 2 sec) of
[ENTER]
button causes by displaying
„dEL?”
ask. If
[ENTER]
button is pressed again, current point
is deleted and new updated number of points of the user defined characteristic is displayed.
