Dimplex SI 35TUR, Инструкция по установке и эксплуатации

Страница: 20 / 58

EN-4 452237.66.54 · FD 9912 www.gdts.one
English SI 35TUR
3 Basic device
The basic device consists of a heat pump for indoor installation
wired ready for use with metal casing, switch box and inte-
grated heat pump manager. The refrigeration circuit is "hermet-
ically sealed" and contains the fluorinated refrigerant R410A in-
corporated in the Kyoto protocol. Information on the GWP
value and CO
2
equivalent of the refrigerant is available in the
chapter Device information. The refrigerant is CFC-free, non-
ozone depleting and non-combustible.
All components required for the operation of the heat pump are
located in the switch box. An outside temperature sensor in-
cluding fixing accessories and a dirt trap are supplied with the
heat pump. The supply for the load current and the control volt-
age must be installed on-site.
Both the heat source system and the brine circuit manifold
must be provided on-site.
1) Switch box
2) Evaporator
3) Liquefier
4) Compressor 1
5) Compressor 2
6) Expansion valve
7) Filter dryer
8) Four-way reversing valve
4 Accessories
4.1 Connection flange
The device can optionally be switched to flange connection
using the flat-sealing connection flange.
4.2 Remote control
A remote display adds convenience and is available as a special
accessory. Operation and menu navigation are identical to
those of the heat pump manager. Connection takes place via an
interface (special accessories) with RJ 12 Western plug.
NOTE
º
In the case of heating controllers with a removable control
panel, this can also be used directly as a remote display.
4.3 Building management system
The heat pump manager can be connected to a building man-
agement system network via supplementation of the relevant
interface plug-in card. The supplementary installation instruc-
tions of the interface card must be consulted regarding the
exact connection and parameterisation of the interface.
The following network connections can be made on the heat
pump manager:
 Modbus

EIB, KNX
 Ethernet
ATTENTION!
!!
If the heat pump or circulating pumps are controlled
externally, a flow rate switch is required to prevent the
compressor from being switched on when there is no volume
flow.
1
4 5
6
2
7
3
8