Operation
Switching On the Heater (see Fig.4)
The controls are located on the right hand side
on the top of the appliance, lift flap to access the
controls - see
Fig.4.
The buttons marked ‘ ‘ controls the electricity
supply to the electronic thermostat. An indicator
beside the ‘ ‘ button shows when the unit is
powered ‘ON’.
Setting Desired Temperature (see Fig.5)
The heater is fitted with an adjustable thermostat
enabling the room temperature to be controlled by
adjusting the slider accordingly. The min setting ‘ ’
represents a room temperature of approximately
5
o
C and may be used for protection against frost.
The ‘MAX’ setting represents a room temperature
of approximately 30
o
C. The ‘ ’ symbol glows when
the elements are actually heating.
Turn on the heater using the ‘ ’ button and move
the thermostat slider to the desired position. When
the room temperature has reached the desired
level, the power to the elements will be reduced,
the heater will then maintain the room temperature
at the chosen level.
NOTE - Should your heater fail to come on when
the thermostat slider is at a low setting, this may
be due to the room temperature being higher than
the thermostat setting.
Background Temperature
When used in conjunction with a remote
programming device supporting background/
setback setting, the heater will automatically
operate at a room temperature setting of 5
o
C less
than the thermostat setting when the programme
is in background/setback mode.
Limiting the thermostat setting
Before wall mounting the product the installer may
wish to limit the heat selection slider movement for
the operator. This may be achieved by removing
the two plastic pins (see ‘x’ in
Fig.6) from the
rear of the thermostat moulding using pliers and
inserting them in the preferred holes to limit the
slider movement.
‘x’
Fig. 4
Fig. 5
Fig. 6
