11
Operation
CAUTION:
During operation
ensure that the receptacle cord is
positioned so that the face is per
-
pendicular to the floor as in Figure 4.
!
NOTE:
Always ensure that the
appliance is in an upright position
before operating the unit.
!
NOTE:
When the cassette
is used in an environment where
background noise is very low, it
may be possible to hear a sound
which is related to the operation of
the flame effect. This is normal and
should not be a cause for concern.
The manual controls for the cas
-
sette are located on the top of
the unit, below the control cover.
(Figure 8)
A. On/Off Switch
Supplies power to the cassette.
B. Mode Selector Switch
Press once to turn on the flame
effect. This will be indicated by an
audible “beep”. Although the lights
turn on immediately it will take 30
seconds before the flame effect
starts.
• Press again to give flame effect
and heat*. This will be indicated
by two “beeps”.
• Press again to return to flame
effect only. This will be indi
-
cated by one “beep”.
•
Press
to put fire in to stand
-
by mode. This will be indicated
by one “beep”.
C. Flame Intensity Control
Adjusts the intensity of the flame
effect when the heater has been
activated.
Turning the control knob clockwise
to decrease the intensity of the
flame effect. Turning the control
knob counter-clockwise will in
-
crease the flame effect.
!
NOTE:
Give the flame genera
-
tor some time to react to changes
you may make on the flame control
knob.
!
NOTE:
When the water tank is
empty the unit will turn off after 30
seconds. See instructions under
Maintenance Section for refilling
tank. When this procedure is com
-
plete, the main lamps will illuminate
but it will take 30 seconds before
the flames return.
D. Thermostat Control*
To adjust the temperature to your
B
A
C
D
Figure 8
Remote Control
Sensor
