Dimplex ECS150HP40A-580, Инструкция по установке и эксплуатации

Страница: 19 / 39

Installation
A
C
la
ss
H
P
In
st
al
la
ti
o
n
a
n
d
Us
er
I
n
st
ru
ct
io
n
s
R
0
2
5
8
3
-1
3
0
5
/1
7
Pa
g
e
19
5.9 Water Module Wiring
All wiring must be carried out by a suitably
qualified person and must be fully compliant with
the current release of Building & Wiring
Regulations. For general wiring configuration see
Figure 7.
The water module has been pre-wired to ensure
minimal additional work is required by the
installer. The following summarises the required
electrical connections which the installer must
make:
 Primary connections, 5.9.1. A three core
cable must be connected between the supply
isolator and the cylinder connector block.
See Figure 7.
 Modbus connection, 5.9.2. The
communication cable between the cylinder
and heat pump must be installed. See Figure
8Figure 9.
 Zoned connections must be wired via the
cylinder PCB, i.e. circulation pumps and/or
zone valves, 5.9.3. See Figure 9.
 Temperature sensors and digital inputs can
be connected to the PCB, 5.9.4 (DI 01-05),
(NTC-DHW and NTC-Zone 1-4). See Figure
10.
5.9.1 Primary Electrical Connections
In both retro fit and new build installations, a 3
core cable must be taken from the isolator
[typically a 16Amp double pole fused spur] and
connected to the primary connector block as
illustrated in Figure 7.
 Live connection taken from a fused spur to
the cylinder connector block, [LHS grey
terminal].
 Neutral and Earth wires must be connected
to the blue and green/yellow connectors
respectively, as per Figure 7.
Note: Solid core cable or ferruled multi core
cable must be used on the primary
connector block.
Figure 7: Primary Electrical Connections, Live, Neutral & Earth