(Figure 6-A) for five (5)
seconds. The Level 1
Indicator Light
(Figure 6-D)
will then flash for 10 seconds.
Within
7.
the 10 seconds
press the ON button located
on the remote control
transmitter. (Figure 7) This
will synchronize the remote
control transmitter and
receiver.
Figure 6
A
B
C
D
E
F
Remote Control
The remote control has a range
of approximately 50ft. (15.25m). It
does not have to be pointed at the
fireplace and can pass through
most obstacles (including walls).
It is supplied with one of 2, 187
independent frequencies, in the
factory, to prevent interference
with other units.
Remote Control Initialization/
Reprogramming
Follow these steps for remote
control initialization and if
required, re-initialization:
Ensure that power is supplied
1.
through main service panel.
Access the manual controls,
2.
(remove the glass doors if
applicable) pull the right hand
steel curtain to the outside of
the unit. (FIGURE 5)
Locate manual controls.
3.
Move the 3-way switch to
4.
“Remote”.
Activate the main power
5.
switch, the red Level 1
Indicator Light will flash
.
(Figure 6-D)
Press and hold the On button
6.
on the manual controls
7
www.dimplex.com
Operation
