Page 4.28
Rev A April 2011
4. Controlling the projector
Digital Projection
TITAN WUXGA 3D, Dual 3D, 330. 660
User Manual
For important information about how Input 8 is used, see
INPUT 8 in the Notes column
, and also Section 4, Overview.
Notes
None of the Geometry controls
are available for Input 8.
Horizontal and Vertical
Aspect Ratio adjustments are
available only when User is
selected in Aspect Ratio, (see
previous page).
WUXGA models only:
The full height of the DMD can
be used only by WUXGA and
UXGA images.
For more information, see
Screen requirements in
section 2. Installation.
Keystone adjustment can be
found in both the Geometry and
Projector Setup menus.
The range of adjustment will
be dependent on the input
resolution.
Phase adjustment can be
found in both the Picture and
Geometry menus, and is
available for graphics based
RGB sources only.
User Horizontal Aspect Ratio
Press
and
to select User H Aspect.
Press
and
to adjust the slider (internal number – adjust to fit).
User Vertical Aspect Ratio
Press
and
to select User V Aspect.
Press
and
to adjust the slider (internal number – adjust to fit).
Keystone
Used to correct for distortion caused by the projector being mounted higher or lower
than the screen.
Press
and
to select Keystone.
Press
and
to adjust the slider.
Phase
Phase should be set automatically by the projector, but can be adjusted manually to
correct for shimmering or poor quality definition on, for example, fine text.
Press
and
to select Phase.
Press
and
to adjust the slider (0 to 32).
•
•
•
•
Geometry menu continued
Downloaded From projector-manual.com Digital Projection Manuals
