Rev A April 2011
Page 4.49
Digital Projection
TITAN WUXGA 3D, Dual 3D, 330. 660
User Manual
4. Controlling the projector
For important information about how Input 8 is used, see
INPUT 8 in the Notes column
, and also Section 4, Overview.
Notes
Setup Menu
Comunication
When fresh batteries are
inserted in the remote control,
it will default to address 00.
Remote control 00 is a master
control, able to control all
projectors.
If two or more projectors are set
to the same address, they can
be controlled from one remote
control, provided they are
connected by cable or in range
of the infra red.
Communication Setup
Press
and
to select Comunication.
Press
to open the Comunication submenu.
Serial Port Baud rate
Press
and
to select Serial Port Baud Rate
Press
and
to select from:
19200
9600
Projector Address
The projector and the remote control need to be set to matching addresses. Read
the note to the right on this page, and follow the instructions in the order shown
below:
1
Set the projector address:
Press
to open the Projector Address control box.
Press
and
to select the address setting.
Press
and
to adjust the address from:
00 to 99
Use
and
to select from
Apply
Press
to apply the new Projector Address.
or Cancel
Press
or
to exit without making the change.
2
Set the remote control address as shown in
Using the control keys
, earlier in
this section.
•
•
Setup menu continued
Downloaded From projector-manual.com Digital Projection Manuals
