Digital Projection Titan 930, Руководство пользователя

Страница: 25 / 145

Digital Projection
M-Vision 930 Series
OPERATING THE PROJECTOR Installation and Quick-Start Guide
17 Rev A January 2014
Operating The Projector
Switching the projector on
1. Connect the power cable between the mains supply and the projector. Switch on at the switch next to the power connector.
Wait until the self-test has completed and the STANDBY indicator on the projector control panel shows amber. The system will be off and
the projector will be in STANDBY mode.
2. Press
ON
on the remote control or
STBY
on the control panel to switch the projector on. The
ON
indicator on the control panel flashes
blue for a few seconds while the lamp comes up to full brightness.
Switching the projector off
1. Press OFF on the remote control or STBY on the control panel, then press the button again to confirm.
The lamp will switch off, the ON indicator on the control panel will start flashing blue and the cooling fans will run for a short time until the
projector enters STANDBY mode.
2. If you need to switch the projector off completely, switch off at the mains power switch next to the power connector and then disconnect
the power cable from the projector.
Notes
See also Connecting The Power
Supply
earlier in this guide.
The self-test is running when all the
LEDs on the control panel are lit.
Use only the power cable
provided.
Ensure that the power outlet
includes a ground connection as
this equipment MUST be earthed.
Handle the power cable carefully
and avoid sharp bends. Do not
use a damaged power cable.