Digital Projection
Titan Quad & Titan 800 Series
INPUT CONNECTIONS
Reference Guide
Ref 41
Rev B November 2012
Input Connections
Inputs 1-8, on the rear of the projector, are limited input frame rates up to 60Hz, but provide access to the full geometric adjustment
capabilities, including Blend and Warp. The side inputs, 9, 10 and 11 provide a very direct path to the DMD™ display, with minimal latency
and high frame rate capability. Inputs 9,10 and 11 therefore provide more limited geometrical adjustment than Inputs 1-8.
Inputs 1-8
To get the best possible image from a source it is important to use the highest quality connection. The following lists show the inputs sorted by
highest quality connection first:
Computer source
•
•
HDMI
(input 2)
Receives digital signal from HDMI-compliant devices. The audio from the HDMI 1 source is available on the SPDIF output
.
•
DVI
(input 3)
This is a DVI-I input, which can receive either analog (DVI-A) or digital (DVI-D) signal from a compatible source. See the
Connection
Guide
for instructions on how to configure this input for your source.
•
DVI
(input 9)
This is a DVI-I input, which can receive digital (DVI-D) signal from a compatible source. See the
Connection Guide
for instructions on
how to configure this input for your source.
•
VGA
(input 1)
Receives analog signal from a computer. When using this input, it is best to use a fully wired VGA cable to connect the source to the
projector. This will allow the source to determine the projector’s capabilities via DDC and show an optimized image. Such cables can be
identified as they have a blue connector shell.
Video source
•
3G-SDI
(input 4)
Uses a BNC connector to receive uncompressed, unencrypted digital video.
•
Component
(input 7)
RGsB or RGBS, or YPbPr
•
S-Video
(input 6)
Uses a 4-pin mini-DIN connector.
•
CVBS1
(input 5)
Uses a BNC connector to receive composite video.
•
CVBS2
(input 8)
Uses an RCA phono connector to receive composite video.
Notes