Digital Projection M-Vision Cine 230, Руководство пользователя

Страница: 44 / 92

Page 4.4 Rev E July 2014
4. Controlling the projector Digital Projection
M-Vision Cine 230, Cine 260, Cine 400
User Manual
The control panel
The projector control panel is designed to be read from the front or rear of the
projector, for ease of use.
The menu navigation keys are similar to those on the remote control, and are
described in detail in
Using the menus
, later in this section.
POWER Press this once to switch the projector ON or twice to switch it to
STANDBY mode.
SOURCE Press this repeatedly to cycle through the input sources, in the
following order:
HDMI 1, HDMI 2, RGB, Composite 1, Composite 2, Video,
S-Video, HDMI 1...
If you select a source that IS connected and active, the projector
will automatically adjust to the parameters of the signal, and
display it.
If you select a source that is NOT connected or active, the
projector will continue searching through the input sources until it
finds a valid signal.
LED status indicators
The indicators on the control panel are as follows:
POWER
off = NO POWER or normal RUNNING mode
steady blue
= STANDBY mode
flashing blue
= WARM-UP or COOL-DOWN mode
ISSUE
off
= NO ERROR
flashing or steady red
= ERROR
Notes
Many features are controlled
from the menus using the menu
navigation keys on the remote
control or the projector control
panel.
For more information about
using the menus, see later in
this section, Using the menus .
Always allow the lamp to cool
for 5 minutes before:
- moving the projector
- changing the lamp
If the red ISSUE indicator is
illuminated continuously or
flashing, see
Error Codes
in
section 6. Appendix , for more
information
Menu
navigation
keys