12
XR2500F User’s Guide
System Setup
System Setup
XR2500F User’s Guide
13
User Profiles Reference
Menu Display
Privilege
ARM
NO
YES
Arm
DIS
NO
YES
Disarm
ALM SLNC
NO
YES
Alarm Silence
SNSR RST
NO
YES
Sensor Reset
DOOR ACS
NO
YES
Door Access
ARM AREA
NO
YES
Armed Areas
OUTPUTS
NO
YES
Outputs ON/OFF
ZN STATS
NO
YES
Zone Status
BYPAS ZN
NO
YES
Bypass Zones
ZONE MON
NO
YES
Zone Monitor
SYS STAT
NO
YES
System Status
SYS TEST
NO
YES
System Test
PROFILES
NO
YES
User Profiles
USR CODE
NO
YES
User Codes
SCHEDULS
NO
YES
Schedules
TIME
NO
YES
Time
DIS EVNT
NO
YES
Display Events
SERV REQ
NO
YES
Service Request
FIRE DRILL
NO
YES
Fire Drill
EXTEND
NO
YES
Extend Schedules
TEMP CODE
NO
YES
Temporary User Code
ANTI PASS
NO
YES
Anti-Passback
ALOW: 1234
___ ANY
Allow: Shift/Time Access
RE ARM DLY
0 – 250
Re-Arm Delay
Changing User Profiles
1. Access the User Menu.
2. Press COMMAND until USER PROFILES? displays.
3. Press any Select key. The keypad displays ADD DEL CHG.
4. Press the far right Select key, under CHG.
4. At the PROFILE NO: - option, enter a profile number and
press COMMAND. The display changes to PROFILE NAME.
5. Press any Select key to display -. Enter a profile name of up
to 16 characters. The default Profile Name uses the Profile
Number. Enter the name and press COMMAND.
6. At the Arm/Dis AREAS: option, enter the area numbers
(1-32) for arming and disarming assigned to this profile.
7. The keypad displays ACCESS Areas: . Enter the area numbers
(1-32) assignment to allow door access for this profile. Press
the COMMAND key.
8. The keypad displays OUTPUT GROUP: -. Enter the number
(1 through 20) for the Output Group assigned to this profile.
Press the COMMAND key.
9. The keypad displays each of the menus as shown in the
Profile Table. You then enable or disable the menu function
for this profile number. Select YES or NO and press the
COMMAND key to advance to the next menu selection.
10. When you complete Selecting all User Profile menu
assignments, the keypad displays the PROFILE CHNGD
message for 4 seconds, indicating the profile is changed.
TEMP CODE
When you select YES for this menu option, and this profile is
assigned to a user code (see next section), the keypad displays
TEMP EXPIRE DATE:. Enter the ending date for the profile to
expire. Default is seven days from today. The system deletes
Temp users at 12:00 AM on the last date.
Содержание XR2500F
Страница 1: ...Fire Command Center User s Guide XR2500F...
Страница 6: ...iv XR2500F User s Guide This page intentionally left blank...
Страница 35: ...This page intentionally left blank...
Страница 36: ...LT 0760 6 05...
