Digital Monitoring Products XR150DFC-R, Руководство по установке, Страница: 10 / 27

XR150FC/XR550FC Series Installation Guide Digital Monitoring Products
5
Fire Command Center LCD Keypad
A Fire Command Center LCD Keyboard is factory installed on the panel enclosure door. The installed, pre‑wired
keyswitch is located to the left of the keyboard. The user can turn the keyswitch to enable the four function keys without
opening the enclosure door. The display and keyboard are factory pre‑wired to the PROG header. For standby battery
calculations, the LCD display draws 92 mA of current in normal, standby, or alarm condition. For more information, refer
to "Power Requirements".
Mounting Additional Keypads, Zone Expanders, and Modules
DMP keypads have removable covers that allow you to easily mount the keypad to a wall or other flat surface using the
screw holes on each corner of the base. Before mounting the base, connect the keypad wire harness leads to the panel
and to any applicable devices. Then, attach the harness to the pin connector to the PCB, mount the base, and install the
keypad cover making sure all of the keys extend through their respective holes.
For mounting additional keypads on solid walls, or for applications where conduit is required, use the Model 695 1‑1/2”
deep backbox or the Model 696 1/2” deep backbox.
The DMP 711, 712‑8, 714, 715, 716, and 717 zone expanders are each contained in molded plastic housings with removable
covers. The base provides you with mounting holes for installing the unit to a wall, switch plate, or other surface.
Mount any additional modules in the panel enclosure using the standard 3‑hole mounting pattern. Refer to the
appropriate product guides for installation instructions.
ALARM
TROUBLE
POWER
COMMAND
1 2 3 4
5 6 7 8
9 0
ABC DEF GHI JKL
MNO PQR STU VWX
YX
ENABLE
SILENCE
RESET
TEST
DRILL
Fire Command Center
Figure 3: Fire Command Center LCD and Keypad