Digital Equipment PRIORIS ZX 5000 MP, Руководство пользователя, Страница: 93 / 169

Expanding Your Server
3-48
Installing or Replacing a Device
Into the Hot-Swap Drive Bay
Hot-swapping allows you to remove or install an SBB while the server re-
mains on-line and active eliminating interference with the server’s opera-
tion. For SBBs, you can use the hot-swap method to replace a device
providing that the device is not active (green activity LED is off).
NOTE:
Not all SCSI controllers support the hot-swap
method. Refer to your SCSI controller documentation to
determine if the hot-swap method is supported.
Also, you might need to reconfigure your server to recog-
nize the devices you installed.
Use the following procedure to install or replace an SBB:
1. Unlock and open right side door.
2. Remove filler panel or SBB by pressing the two tabs together to
pull filler panel or SBB out (A, Figure 3-21).
3. Insert new SBB into the guide slots and push it in until it is fully
seated and the mounting tabs engage the shelf.
4. Close and lock door.