Setup and Configuration
4–4
Verifying Port Status
Check each connection by viewing the port status LEDs shown in the following table.
(Refer to Chapter 2 for further information on these LEDs.)
LED
State
Indication
100TX
ON
Communications have been set to 100 Mb/s
TX/RX
ON
Traffic is traversing the port
Full Duplex
ON
Communications have been set to full
²duplex mode
Select/Link
ON
Port has established a valid network connection
If the Select/Link status LED is not functioning properly, or if you experience any other
difficulties in setting up the switch, refer to Appendix A for troubleshooting information.