3–8
Installation
NOTE
The DECrepeater 90C can be installed into or removed from
the DEChub 90 Ethernet backplane while power is applied to
the backplane (hot swap).
3.
If this is a new installation, supply power to the backplane.
4.
All LEDs on the repeater turn on either immediately or at initial
power-up. After approximately 0.5 seconds, the port 0 status LED and
port status LEDs turn on with intensity proportional to the amount of
activity on the indicated port.
NOTE
The port status LEDs for unconnected ports should turn off
when network traffic is established.
Install and verify devices.
1.
Connect the desired devices to ports 1 to 6, using correctly terminated
ThinWire segments. The corresponding port LEDs should turn on.
2.
Verify the operation of each device you plan to use by connecting and
sending information to each port you have connected.
The DECrepeater 90C is now installed.