Choose option 13, then
go to the section titled
Start Redirect Mode.
The DECrepeater 900GM does not
support
Option [9] Downline
Upgrade
from this menu.
You must choose
Option [13]
Start Redirect Mode
to perform
a downline upgrade to this module.
11
DECrepeater 900GM Installation and Configuration
Configuring the Module (Cont.)
3. Press
Return
on the setup port device a few times until a menu appears.
a. If the module is connected to the setup port on the DEChub ONE dock-
ing station, the
DECrepeater 900GM INSTALLATION MENU
ap-
pears. Go to the section titled DECrepeater 900GM Installation Menu
(DEChub ONE Options).
b. If the setup port device is connected to the Hub Manager setup port on
the DEChub 900, the
DEChub 900 MultiSwitch INSTALLATION
MENU
appears (see following example).
The following is an example of the
DEChub 900 MultiSwitch INSTALLATION
MENU
:
DEChub 900 MultiSwitch
DEChub 900 MultiSwitch INSTALLATION MENU
[1] Reset with Factory Defaults
[2] Reset with Current Settings
[3] Show Current Settings
[4] Set SNMP Read/Write Community
[5] Add SNMP Trap Addresses
[6] Delete SNMP Trap Addresses
[7] Dump Error Log
[8] Set In-Band Interface IP Address
[9] Downline Upgrade
[10] Set Out-of-Band Interface IP Address
[11] Set Out-of-Band Interface Port Speed
[12] Start Event Display Mode
[13] Start Redirect Mode
Enter selection : 13
Return
c.
Choose option 13, then go to the section titled Start Redirect Mode.