Digital Electronics Corporation APL3600-TA, Руководство по установке

Страница: 14 / 18

14
(2) Push the Opening button by a small and flat
screw driver to open the desired pin hole.
(3) Insert each pin terminal into its each
hole. Release the Opening button to
clamp the pin place.
(4) After inserting all three pins, insert the
Power Plug into the Power Connector at
PL. Fix the plug with two minus screws.
• Confirm that all wires are connected
correctly.
• The torque required to tighten these
screws is 0.5 to 0.6 N•m [5-7Lb•In].
• To prevent the possibility of a terminal
short, use a pin terminal that has an
insulating sleeve.
2. Wiring the DC type power supply cable
• When the FG terminal is connected, be
sure the wire is grounded. Not ground-
ing the PL unit will result in excessive
noise. Use your country’s applicable
standard for grounding.
„
Power Cord Specifications
Use copper conductors only.
„
Power Connector (Plug) Specifications
• Accompanying power supply connector is
CA5-DCCNL-01 of Pro-face or
GMVSTBW2.5-3-STF-7.62 of Phoenix
Contact.
When connecting the power code, use the
following items when performing wiring.
(Items are made by Phoenix Contact.)
„
Connecting the PL Power Cord
(1) Confirm that the power is not supplied to
the PL unit.
(2) Loosen three screws in the center of the
Power Connector (plug).
(3) Strip the power cord, twist the conductor’s
wire ends, insert them into the pin terminal
and crimp the terminal. Attach the terminal
to the Power Connector.
• Use a flat-blade screwdriver (Size 0.6 x
3.5) to tighten the terminal screws.
The torque required to tighten these
screws is 0.5 to 0.6 N•m [5-7Lb•In.].
Power Cord
Diameter 0.75 to 2.5mm
2
(18 - 12 AWG)
Conductor Type Simple or Stranded Wire
*1
*1 If the Conductor’s end (individual) wires are not
twisted correctly, the end wires may either short
against each other, or against an electrode.
Conductor
Length
L
N
FG
Opening button
Black
White
Green/Yellow
AC power supply cable
7mm
[0.28in]
+ 24V
- 0V
FG
Grounding
Terminal
connected
to the PL
chassis
Recommended
Driver SZF 1-0.6x3.5
(1204517)
Recommended
Pin Terminals
AI 0.75-8GY (3200519)
AI 1-8RD (3200030)
AI 1.5-8BK (3200043)
AI 2.5-8BU (3200522)
Recommended
Pin Terminal
Crimp Tool
CRIMPFOX ZA 3
(1201882)
+
Insertion Direction
−
FG