SETTING PRINT DELAY AND LINE SPEED
LINE SPEED
– This setting adjusts the width of the printer message on the
product. This setting should be adjusted to produce the desired print on the
product. Line speed can be increased or decreased to stretch or compress the
message to fit the desired print area.
PRINT DELAY
– This setting adjusts the location of the printed message on the
product.
EVSC STOPPED
HD1< - - SPEED=120
EVOLUTION SC
Access to these parameters is possible when the
unit is in either the STOPPED or PRINTING mode
as shown to the left.
Pressing
the
delay key allows the user to
determine the amount of print delay. Each count at
a normal aspect ratio is approximately 0.0208”.
This will vary according the amount of
compression or expansion used.
EVSC PRINTING
HD1< - - SPEED=120
EVOLUTION SC
SETTING LINE SPEED
Normally, the system will be set to use the internal
time base for line speed control. The default value is
100, which creates a normal width character on a
line moving at 100 ft per min. The print can be
narrowed by increasing the number and widened by
decreasing the number. Pressing
accesses this
parameter. Once pressed, a new screen appears, as shown to the left.
Changes can now be made by using
or
. The range of values for
character width is 1 to 200. Once the desired number is chosen, press
to
save your entry.
< - - SELECT - - >
LINE SPEED = 100
If external encoder is enabled and the unit is in the
PRINTING mode the user has the option of
adjusting the compression ratio of the printer
message. Changes may be made by using
or
. Once the desired number is chosen, press
to save your entry.
< - - SELECT - - >
ENCODER DIV = 4
19
EVOLUTION SC
SYSTEM MANUAL Issue 1.1 15 November 2006
