DG-BG1100N User Manual
59
Entries in this table allow you to configure one IP pool for specified source IP address from LAN,
so that one packet whose source IP is in range of the specified address will select one IP address
from the pool for NAT.
The following table describes the parameters of this page:
Field
Description
Rule Index
The Virtual server rule index for this VC. You can specify 10
rules in maximum. All the VCs with single IP will use the same
Virtual Server rules.
Rule Type
Choose the One-to-One, Many-to-One, Many-to-Many
Overload, Many-to-Many No Overload, or Server.
Local Start/End
IP
Enter the local IP Address you plan to map to. Local Start IP is
the starting local IP address and Local End IP is the ending
local IP address. If the rule is for all local IPs, then the Start IP
is 0.0.0.0 and the End IP is 255.255.255.255.
Public Start/End
IP
Enter the public IP Address you want to do NAT. Public Start IP
is the starting public IP address and Public End IP is the ending
public IP address. If you have a dynamic IP, enter 0.0.0.0 as
the Public Start IP.
4.4.4 VLAN
Choose
Advanced Setup > VLAN
, the page shown in the following figure appears.
