Button Definition
There is one multi-function push button "WEC/Reset" in this device.
According to different button pressed duration, the device will take
specific reaction. For ease of interacting with the device, you can also
check the Status LED to determine when to release the button.
The Reset/WEC button's behavior is defined below:
Function
Button
Description
Easy
Configuration
(Master to Slave)
WEC/Reset
(Press 3 sec)
There are two alternative AP modes defined for the
device to operate with WEC (Wireless Easy
Connection) feature. One is Master Mode (by
default), and the other is Slave Mode.
Please manually configure the Wireless Setting for
the Master AP through web UI first, and also
prepare a Slave AP that already been set to Slave
Mode.
1. Press the WEC/Reset button of the Master AP
for 1~3 seconds, release it to trigger the WEC
process. Then, the WiFi LED flashes fast.
2. Press the WEC/Reset button of the Slave AP
for 1~3 seconds, release it to trigger the WEC
process. Then, the WiFi LED flashes fast.
Note: The Slave AP must be an un-configured
one, if it has already been paired and
configured before, please reset its Slave
configuration first.
3. After a few seconds (normally about 30~60
seconds). The Master and Slave APs can be
paired automatically, and auto-duplicates the
VAP1 wireless setting of the Master AP as that
of the Slave AP.
(If there is something wrong during paring the
two devices, the process will be finished in 2
minutes.)
4. Once
the
easy
configuration
process
completed, the Status LED will be recovered to
its original behavior (prior to you triggered it).
And the WiFi LED will be Solid Green when
Slave AP is connected to the network.
Easy
Configuration
(Slave to Slave)
WEC/Reset
(Press 3 sec)
Besides the above “Master to Slave” configuration,
the easy configuration process also supports
“Slave to Slave” configuration.
1. Press the WEC/Reset button of the first Slave
AP (say Slave1 that has been paired and
configured) for 1~3 seconds, release it to
trigger the WEC process. Then, the WiFi LED
flashes fast.
2. Press the WEC/Reset button of the second
Slave AP (say Slave2 that is an un-configured
Slave AP) for 1~3 seconds, release it to trigger
the WEC process. Then, the WiFi LED flashes
fast.
3. After a few seconds (normally about 30~60
seconds). The Slave1 and Slave2 APs can be
paired automatically, and auto-duplicates the
wireless setting of the Slave1 as that of the
Slave2.
(If there is something wrong during paring the
two devices, the process will be finished in 2
