Hardware Installation
2-9
with the DG-SA-GS4600-EM-2SFP+.
Note: the 2SFP+ extended module does not support hot swappable.
DG-SA-GS4600-EM-2SFP+ extended module can insert SFP+ fiber transceiver.
2.3.6 DG-SA-GS4600-EM-2SFP Extended module Installation
DG-GS4600S series provide 10Gb slots. The procedure for installing the
DG-SA-GS4600-EM-2SFP module and the SFP 1Gb fiber transceiver is shown below:
Step 1: Put on an ESD wrist strap (or antistatic gloves).
Step 2: Insert the DG-SA-GS4600-EM-2SFP module to the guide rail inside the 10Gb
module slot.
Step 3: Push the DG-SA-GS4600-EM-2SFP module along the guide rail gently until it
comes into contact with the machine panel.
Step 4: Insert the SFP transceiver to the guide rail inside the DG-SA-GS4600-EM-2SFP.
Do not put the SFP transceiver up-side-down.
Step 5: Push the SFP transceiver along the guide rail gently until it comes into contact with
the DG-SA-GS4600-EM-2SFP.
Note: the 2GB extended module does not support hot swappable.
Caution!
Do not stare directly at the 2 fiber bores in the fiber transceiver when the switch is in
operation, otherwise the laser may hurt your eyes.
2.3.7 Copper Cable/Fiber Cable Connection
Copper cables should be connected as below:
Step 1: Insert one end of the Ethernet cable to the RJ-45 Ethernet port in the switch
copper cable line card;
Step 2: Insert the other end of the Ethernet cable to the RJ-45 Ethernet port of other
device;
Step 3: Check all status indicators for the corresponding ports; a lighted LED indicates that
the link has been established, otherwise the link is not ready and the cable should be
examined.