DIGIQUEST
28
Replace the partitions or place a line amplifier.
Contact an antennist technician.
Pictures on the screen appear split (framed)
The decoder needs good signal quality for proper operation.
Check that the reception system (antenna) is working properly.
The signal is too weak because of bad weather conditions, for
example: wait for the signal to recover.
Remote control does not operate the decoder
Make sure the decoder is turned on.
Make sure that the remote control is pointing towards the front
panel of the decoder and that there are no obstructions on the path.
Check the remote control batteries: they may have been inserted in
the wrong direction or discharged.
Check that no liquid has leaked from the batteries.
Check that there are no stuck keys.
Make sure that there is no direct sunlight on the decoder.
A temporary transmission error has occurred, or the decoder
software has lost some of its settings. Turn the unit off and
disconnect it from power; allow a few minutes to elapse and then
turn it on again.
Make sure that there are no transmitters in the vicinity that could
interfere with remote control actions.
An incorrect function has been selected. Press the right key.
Verify that the decoder is properly connected to the power outlet and
TV.
No image
or “No Signal" message
When connecting the decoder with HDMI
,
you must select the
source (e. g. HDMI1) for the input used by pressing the SOURCE
button on the TV remote control (depending on the brand, it can
also be identified with INPUT, AV, AUX, ZERO, etc.).
Check the HDMI or SCART cable
.
Disconnect and then reconnect the decoder.
"No Signal Absence" appears on the channel already tuned.
Reset the decoder (see relative paragraph), or check the system status.
The word Codified (Scrambled) appears
The channel viewed is part of a paid package.
