Digimerge DH200+R Series, Инструкция по эксплуатации

Страница: 154 / 176

142
Appendix E: Connecting PTZ Cameras
APPENDIX E: CONNECTING PTZ CAMERAS
You can connect RS-422/485 PTZ cameras (not included) to the PTZ Control Block on the rear
panel of the system.
PTZ CAMERA
(not included)
Connecting a PTZ camera (not included).
Connect to T+ and T-
BNC
To install a PTZ Camera:
1. Connect the Transmit Cable to the RS-422/485 TX (+) port of the PTZ block on the rear panel.
2. Connect the Receive Cable to the RS-422/485 TX (-) port of the PTZ block on the rear panel.
3. Connect the video cable to a BNC port (usually channel 1).
4. Open the Main Menu and select
CAMERA .
5. Beside PTZ, click the SETUP button.
6. Under MODLE, select the protocol of your PTZ camera.
7. Enter the PTZ camera’s BAUD RATE.
NOTE: The PTZ camera settings depend on the type of PTZ camera. Please refer to the manual
for your brand and model of PTZ camera.
8. If desired, enter the Preset numbers (PRESET No.) and Dwell Time.
9. Press the
ENTER button to save your settings.