Digilin ColourTheme 3, Руководство пользователя

Страница: 8 / 20

ColourTheme 3 - RGB DMX Controller
User Manual
7.1 - 17 September 2020
digilin.com.au Page 8 of 20
+617 3899 1267
C-Bus Mode
This mode allows the Colour Theme Controller to be connected to a C-Bus network via the C-Bus PC
Interface unit. The Colour Theme will respond to dimming, on & off commands on the C-Bus lighting
application network, using two consecutive group addresses (base address can be set via User
Configuration) as described in Table 3. This is achieved by placing a dummy 2 Channel Dimmer in the C-bus
network during commission at the corresponding address.
Note that the Colour Theme Controller configures the PC Interface at start up to repeat commands from
the network. As such if the PC interface loses power the Colour Theme Controller will also need to be
reset.
G r o u p A d d r e s s C - B u s C o m m a n d
A c t i o n b y C o l o u r T h e m e
C o n t r o l l e r
Group Base Address
(as set in User
Configuration)
On Turn on
Off Turn off
Dim with 4 second ramp
Set show to range 1- 100 (as per level). Turn on if
needed
Dim with 8 second ramp
Set show to range 100- 200 (as per level). Turn
on if needed
Dim with 12 second ramp
Set show to range 200- 300 (as per level). Turn
on if needed
Dim with 20 second ramp
Set show to range 300- 400 (as per level). Turn
on if needed
Group base A 1
On Turn on, set Dim to 100%
Off Turn off
Dim with and ramp to 0 Turn off
Dim with any ramp to any other
value
Set dim to value /10
Turn on if needed
Table 3 C-Bus Commands