Digikeijs DR5013 DIGIREVERSE, Инструкция по эксплуатации

Страница: 31 / 32

DR5013 DIGIREVERSE
P 31
www.digikeijs.com ® R - Bus, B - Bus are trademarks which are registered in the name of Modelleisenbahn GmbH. XpressNet and RS - Bus is a trademark registered in the name of Lenz
Stand 2021 - 07 - 06
Place the locomotive on the sensor track
S0 .
The feedback S0 in the app now shows the
assignment ( yellow dot ).
— > If no busy message is displayed, the
wiring or the address assignment in the
app of
S0 must be checked.
Place the locomotive on the sensor track
S1 .
The feedback S1 in the app now shows the
assignment ( yellow dot ).
— > If no busy message is displayed, the
wiring or the address assignment in the
app of
S1 must be checked.
Test sequence of the feedback units
S0,S1,S2,S3 using the App:
6.0 Commissioning instructions DR5013 with sensor tracks S0,S1,S2,S3
(with connection to PC)
To check the connection of the DR5013, use this procedure. This can be used to test if the wiring is correct and there is no fault. To do this, the DR5013 must be connected to the PC via USB
and the configuration tool must be started. Note: A connection via USB to the DR5000 or any other digikeijs device connected via USB must be disconnected first. If this note is observed, the
test can be carried out without any problems even with active track voltage.
Place the locomotive on the sensor track
S2 .
The feedback S2 in the app now shows the
assignment ( yellow dot ).
— > If no busy message is displayed, the
wiring or the address assignment in the
app of
S2 must be checked.
Place the locomotive on the sensor track
S3 .
The feedback S3 in the app now shows the
assignment ( yellow dot ).
— > If no busy message is displayed, the
wiring or the address assignment in the
app of
S3 must be checked.
S0
S1
S3 S2
At the end of the test series, place the locomotive on the sensor
track
S0 and drive in direction S1 over the double track separa-
tion point into the reversing loop track ( T ).
If the blue LED does not light up or a short circuit is triggered at
the DR5013, the track connections at the track input of the
DR5013 must be replaced.
Finally go through the complete reversing loop again to test the
connection completely:
S0 - > S1 - > T - > S2 - > S3
Blue LED Indication of polarity of the
reversing loop track