DR5013 DIGIREVERSE
P 22
www.digikeijs.com
® R
-
Bus, B
-
Bus
are trademarks which are registered in the name of Modelleisenbahn GmbH. XpressNet and RS
-
Bus is a trademark registered in the name of Lenz
Stand 2021
-
07
-
06
4.8 Properties of sensor tracks
The properties of the sensor tracks and the feedback number are assigned to the reversing loop here.
1
2
3
4
5
6
7
8
9
1)
Switch
-
off delay Feedback in
ms.
2)
turnout mode
Mode how the turnout address is used.
Off
No action.
3)
Follow
The polarity of the reversing loop follows the position of the
turnout.
Set
S1 and S2 set the turnout.
Both
Both (Follow, Set) options are considered
4)
Turnout status
Condition of the turnout when the reversing loop is in its initial position.
5)
Closed
Position of the turnout straight
6)
Thrown
Position of the turnout curved
7)
Feedback number Sensor track 1 (
S1
)
(Sensor track for polarity switching)
8)
Feedback number Sensor track (
S0
)
(Reversing loops Enter entry indicator
*optional*
if not used Feed-
back indicator number "0".)
10
11
6)
turnout address Entrance turnout of the reversing loop
7)
Feedback number Sensor track (
S3
)
(Reversing loops Enter entry indicator
*optional*
if not used Feedback in-
dicator number "0".)
8)
Feedback number Sensor track 2 (
S2
)
(Sensor track for polarity switching)
9)
Feedback number Reverse loop track (
T
)
10)
Accept current settings.
11)
Cancel
12)
First switch (1.magnetic article address) to be addressed.
setting:
0 = Roco® (shift of magnetic article add4)
1 = Magnetic article addresses Standards
-
compliant to RCN 213
(
default setting!)
13)
turnout position indicator
14)
These arrows symbolize the entry or exit into the reversing loop.
15)
These points indicate which feedbacks have triggered.
12
13
14
15
15
