DR5013 DIGIREVERSE
P 19
www.digikeijs.com
® R
-
Bus, B
-
Bus
are trademarks which are registered in the name of Modelleisenbahn GmbH. XpressNet and RS
-
Bus is a trademark registered in the name of Lenz
Stand 2021
-
07
-
06
4.6.0 Module properties
1
2
3
4
5
6
7
8
9
10
11
1)
Display Logging Window.
2)
Select language.
3)
Module address in LocoNet®.
4)
Waiting time after the central unit has transmitted power on before the track
voltage is activated in the reversing loop.
5)
Report feedback contacts after switching on.
6)
Waiting time after switching on before the contacts are reported.
7)
Waiting time until the track voltage is switched off if a short circuit has been
detected.
8)
Short circuit Send message via LocoNet® (track voltage is switched off glob-
ally).
None
Do not send a short circuit message via LocoNet®.
CP_OFF
Send short circuit message via LocoNet®.
OPC_PEER_XFER
Send short circuit message via LocoNet®.
(Uhlenbrock® Specification)
Both
Send both messages via LocoNet.
9)
Switch the track voltage on again automatically after a short circuit.
10)
Waiting time after a short shot before the track voltage is reactivated.
11)
Module Setting Export/Import
12)
Accept current settings
13)
Cancel
14)
Railcom® Use channel 2 for additional address recognition.
Up to 4 addresses can then be detected simultaneously by one detec-
tor.
15)
Number of bits to be counted before a busy message is issued.*
16)
Number of Railcom bits to be counted before direction recognition
takes place.*
17)
Waiting time until the direction recognition is measured in a stable
way.*
18)
Railcom® Detection with Logging
*The lower the value, the faster the detection is.
Notice!
Not all functions are supported by all decoders. Please refer to the
respective decoder manual for details.
12
13
12
13
14
15
16
17
18
