DR4024 Servodecoder
P 7
www.digikeijs.com
® R-Bus, B-Bus
are trademarks which are registered in the name of Modelleisenbahn GmbH. XpressNet and RS-Bus is a trademark registered in the name of Lenz
Stand 2018.10.22
3.1 Programming the turnout address
The turnout addresses are always assigned by a turnout command!!!
Make sure the DR4024 is powered from the decoder's power connector. It is best to use a switching power supply with at least 12V DC output voltage
and 2A output power. The signal connec on of the decoder must be connected to the main track output of your control panel!
1.
Call up the desired magne1c ar1cle address which the DR4024 is to receive as the start address at the central unit, handset controller, app, etc.
2.
Press the programming bu2on on the DR4024, the red LED will light up con1nuously.
The decoder is now in programming mode.
3.
The next step is to switch the desired turnout address with the control panel, the app or the handset control.
DR4024 as the start address.
4.
The programming mode is automa1cally terminated aJer switching the turnout address.
The red LED goes out again to indicate that the programming mode has been exited.
5.
The DR4024 now occupies a maximum of 8 addresses star1ng with the first switched turnout address.
The
start address
(turnout address) for the DR4024 is always assigned via a
turnout command
and
not via the CV1
!!!
If the CV1 is nevertheless wri2en with an address, the decoder can
no longer be programmed with the locomo ve address 9999!
Supply voltage
12-18V DC/AC
Recommended min.
12V DC 2A
