Configure ports
Host mode configuration
Digi CM User Guide
48
3
Choose an individual port >
Apply Port Settings
.
4
Select Enable or Disable from the drop down menu.
5
Click
Save to flash
and continue with other configurations or click
Save & apply
.
Note
When changing a parameter for all ports, all settings of the complete page are applied to all
ports.
Host mode configuration
The Digi CM unit provides four modes of communication between serial devices and remote hosts.
Console server, terminal server, dial-in modem, and dial-in terminal server. These are described in
the following sections.
Console server mode
Configuring a serial port as a console server creates a TCP socket on the Digi CM unit that listens for
a Telnet or SSH client connection. When you connect to the TCP socket, you have access to the
device attached to the serial port as though the device were connected directly to the network.
RawTCP is also supported with the Console Server Mode.
Содержание Digi CM 16
