SECTION #2
SETTING THE CODE SWITCHES ON THE MODEL’S 5040 AND MODEL 5042
SINGLE BUTTON MINI TRANSMITTERS
Use your finger to slide the “code switch hatch” from the Digi-Code receiver or locate
the code switches on the back of your Stanley operator.
The digital code is determined by
the position of the 10 small switches numbered 1 through 10 located in the receiver and
the transmitter ( see diagram #2 ). Set both code switches to the code of your choice,
being sure both are set the same since a different setting of just one switch will prevent
operation. Any combination of “on” or “off” positions can be selected by using a pencil
or a pen. (Note: The switches are in the “on” position when the switch is depressed
toward the number.) We strongly urge that several coding schemes be avoided: ALL ON;
2,4,6,8,10, ON. These positions are similar to our or other manufacturers test positions, or
are frequently used.
Once the codes have been set, check operation and reassemble products.
( Diagram #2 )
( Diagram #3 )
Model – 5040 (300mHz) or 5042 (310mHz)
