background image

OPERATIONAL CHECK

To check operation, move back about 50 feet and press the transmitter button. Operation
should be reliable at this distance but environment and location of both the transmitter
and receiver will effect the range. Try different mounting locations and positions in the
vehicle. If operation is still undesirable, the problem may be isolated by:

1.

 

Checking the door operator. If the door will not open when the wall button is
pressed, the problem is likely to be the operator. If the door will open by pressing
the wall button, but not when the radio control button is pressed, the problem is
probably in the radios.

2.

 

Replacing the transmitter battery.

If, after performing the above operational checks, the controls still do not function, they
should be returned to your dealer for repair or replacement.

WARRANTY

All Digi-Code door related products carry an eighteen (18) month warranty against
defects in workmanship or material. This warranty begins at the date of manufacture, for
eighteen months. Digi-Code warrantees our product only to our authorized dealers and
distributors, and not to the end customer. If you have any questions about our warranty,
please ask your dealer to determine the nature and scope of their warranty. Digi-Code
does not assume, and is not responsible for, any real or consequential damages from
claims against the performance of our product, nor is it liable for any costs related to the
loss of life, property, or revenue. Further, Digi-Code is in no way responsible for
installation of our product, and will assume no cost related to reinstallation or removal.
Digi-Code’s warranty is in lieu of all other warrantees, expressed, or implied.

CAUTION

:  Any changes or modifications in intentional or unintentional radiators which

are not expressly approved by Digi-Code Inc. could void the users authority to operate this
equipment. This applies to intentional and intentional radiators certified per part 15 of the
FCC rules and regulations.

DIGI-CODE, INC.

307 ROBBINS DR. 

 TROY,  MICHIGAN  48083

(248) 589-3645

Part # 5/3/00-5040

Содержание 5040






Отзывы: