12
8. ProGramminG
this section explains the programming features, use of buttons and the steps
necessary to assign irrigation schedules. to program the controller use the left
button to select the desired programming mode, the right button to make the entry
flash and the plus minus buttons to change the value.
Note:
Only a flashing character can be changed.
DIG controllers are programmed with the aid of four buttons:
Use to select the desired programming mode
Use to lower the value of the selected parameter (e.g. deducts an hour)
Use to raise the value of the selected parameter (e.g. adds an hour)
Use to select the parameter to be changed (hour, minute, etc.). to implement
the changes, the selected parameter must be flashing.
If no changes are implemented, the controller will always revert to the main screen.
9. settinG current time and day of the WeeK
to enable the controller to operate properly, the
current time and current day of the week
must first be set. the steps below explain
how to set the day and time.
Press and the hour digit will flash. Use
the or to set the current hour (note
AM and PM designations). Press and the minute digit flashes. Set the current
minute using or . Press and a flashing arrow will appear under “M” for
“Monday”. Use the or to move the arrow to current day. Press to proceed
to the next step.
Note:
If the last data entered stops flashing, press again to resume programming.
