•
5
•
FEATURES
1.
Jump start On/Off switch
2.
Built-in light and switch
3.
110V AC household
power outlets (2)
4.
12V DC power outlets (2)
5.
Cables with clamps
6.
USB port ON/OFF button
7.
USB ports (2)
8.
Air compressor hose
9.
Select battery % / inverter /
/ compressor button
10.
Display LEDs
11.
Digital display
12.
Compressor ON/OFF button
1
2
3
5
7 6
9
8
10
4
11
12
CHARGING THE INTERNAL BATTERY OF THE PORTABLE POWER
IMPORTANT!
CHARGE IMMEDIATELY
AFTER PURCHASE, AFTER EACH USE
AND EVERY 30 DAYS, TO KEEP THE
PORTABLE POWER’S INTERNAL
BATTERY FULLY CHARGED AND
PROLONG BATTERY LIFE.
CHECKING THE LEVEL OF THE
INTERNAL BATTERY
To check the internal battery’s charge
status, Press the
Select
button until the
Battery % LED
lights. The Digital Display
will show the battery’s percent of charge.
Charge the internal battery if the display
shows it is under 100%.
NOTE:
The internal battery’s percent of
charge is most accurate when the jump
starter has been disconnected from all
devices and charging sources for a few hours.
CHARGING THE INTERNAL BATTERY
Charge the internal battery for the Portable
Power using an extension cord (not included).
NOTE:
Use of an improper extension cord
could result in a risk of fire and electric shock.
1.
To charge, flip the AC connector on
the back of the unit DOWN and plug in an
18 AWG or larger extension cord.
2.
Plug the extension cord into a 120VAC
electrical wall outlet.
3.
While the jump starter is charging, the
marching dashes
will show on the
digital display. When the internal battery
is fully charged, the display will show
ioo
.
Complete charging may take up to 72 hours.
4.
When the internal battery is fully charged,
the charger will automatically go into
maintain mode and maintain the battery
at full charge without damaging it. When
in maintain mode, the
Battery %
LED will
pulse
, as long as there is an AC cord
connected to the charging port.
5.
Charge the jump starter as soon as
possible after use.
CHARGING THE INTERNAL BATTERY
WHILE DRIVING
You may also charge the internal battery
while driving, using a male-to-male
charger cable (part number 94500109 –
not included).
IMPORTANT:
DO NOT CHARGE INTERNAL
BATTERY FOR MORE THAN 30 MINUTES
OR LEAVE THE BATTERY UNATTENDED. IT
COULD EXPLODE, CAUSING PROPERTY
DAMAGE OR PERSONAL INJURY.
1.
Make sure the car is running.
2.
Insert one end of the accessory cable into
the 12V DC power outlet.
3.
Insert the other end of the accessory
cable into the vehicle’s accessory outlet
(lighter socket).
NOTE:
The
Battery %
LED
does not
operate during this method of charging.
Using this method to charge the battery
overrides the maintain mode and the battery
can be overcharged.
4.
Monitor the progress of the charge by
pressing the Select button until the
Battery % LED lights. When the battery is
fully charged, disconnect the accessory
cable from the Portable Power, then from
the lighter socket of the vehicle.
NOTE:
Completely disconnect the charger
cable when the engine is not running.
