DIEBOLD AccuVote-OS 1.94, Руководство по оборудованию

Страница: 40 / 73

Maintenance and Repair
© Diebold Election Systems, Inc. 2002 AccuVote-OS Hardware Guide 32
7) Insert the motor shaft into the motor coupler and release the ballot deflector. This should allow
the motor coupler to slide completely over the motor shaft and away from the front of the ballot
box.
8) Position the left side of the deflector so that it is in near vertical alignment with the divider
separating the right and left bins of the ballot box.
9) While holding the deflector in this position, use a stubby Phillips screwdriver (+) to lightly
tighten one of the set screws that secure the motor coupler to the motor shaft.
10) Using the procedure described in Testing the ballot deflector in Chapter 5: Diagnostics Mode
in this guide, verify that the left and right bin open positions correspond to those displayed on the
LCD. Monitor the AccuVote-OS LCD on the open ballot box lid as the deflector is shifted from left
to right open position and back again.
The deflector should operator symmetrically around an imaginary center line drawn through the
motor coupler from the top to the bottom of the ballot box.
11) If the deflector is not shifting properly to the positions indicated on the LCD, adjust the
deflector by loosening the lightly tightened set screw, repositioning the deflector and lightly tighten
the screw. Repeat step 10.
12) When the deflector is properly positioned, install the second screw on the motor coupler.
Firmly tighten both set screws.
13) Remove the lift arm from the ballot box lid and close and lock the ballot box.
4.2.25. Removing the ballot deflector motor
The AccuVote-OS should not be installed in the ballot box while removing the ballot deflector
motor.
Unlock and open the ballot box lid and support on the ballot box lift arm.
1) Remove the ballot box deflector using the procedure previously described in Removing the
ballot deflector .
2) Note that the ballot box deflector connects to the ballot box motor shaft at the back of the ballot
box. The ballot box deflector motor is concealed behind a plastic motor mount bracket that
extends across the ballot box. The ballot box deflector cable connects the deflector connector on
the ballot box lid to the ballot box deflector motor.
Detach the ballot box deflector cable from the ballot box deflector motor cable.
3) Using a Philips (+) screwdriver, loosen and remove all six screws holding the ballot box
deflector motor onto the plastic motor mount bracket. You must grip the motor firmly against the
plastic motor mount bracket in order to remove the screws. Cradle the motor in your hand as you
are removing the last of the screws in order to prevent the motor from dropping into the ballot
box.
4) Remove the motor from the plastic motor mount bracket once it has been freed from the motor
mount bracket.
5) Remove the lift arm from the ballot box lid and close and lock the ballot box.
4.2.26. Installing the ballot deflector motor
The AccuVote-OS should not be installed in the ballot box while installing the ballot deflector
motor.
Unlock and open the ballot box lid and support on the ballot box lift arm.