DIEBOLD AccuVote-OS 1.94, Руководство по оборудованию

Страница: 39 / 73

Maintenance and Repair
© Diebold Election Systems, Inc. 2002 AccuVote-OS Hardware Guide 31
•
two-wire modem power
6) Press the Phone cable plug into the Phone jack on the modem.
7) Press the Line cable plug into the Line jack on the modem.
8) If the two-wire modem power cable connector has been removed, you must reconnect the
cable to pin P2 on the CPU board. Plug the connector on the other end of the cable into the
power jack on the modem.
9) Power the modem on before replacing the AccuVote-OS cover.
10) Replace the unit cover using the procedure previously described in Replacing the cover .
4.2.23. Removing the ballot deflector
The AccuVote-OS must be removed from the ballot box in order to remove the ballot deflector.
1) Unlock the ballot box lid.
2) Lift the lid and prop it up on the lift arm by inserting the end of the arm into the notch in the lid
of the ballot box.
3) Use a stubby Phillips screwdriver (+) to loosen the two set screws on the motor coupler. The
motor coupler is located at the end of the ballot deflector and connects the deflector to the motor.
4) Grasp the end of the ballot deflector with each hand holding the end of each deflector flap, the
thumbs propped against the deflector motor housing. Push against the deflector motor housing
with your thumbs as the remaining fingers grip the deflector flaps in order to release the motor
coupler from the motor shaft.
The front of the ballot box may flex as a result of this action.
5) Angle the deflector up slightly and move it toward the rear of the ballot box until the pivot pin at
the front of the ballot box is withdrawn from the pivot socket.
6) When the deflector is completely free, lift the deflector out of the ballot box.
7) Remove the lift arm from the ballot box lid and close and lock the ballot box.
4.2.24. Installing the ballot deflector
The AccuVote-OS should not be installed in the ballot box before installing the ballot deflector.
After the deflector is in position, an AccuVote-OS can be installed into the ballot box in order to
verify ballot deflector alignment in Diagnostics Mode.
Exercise caution while working inside the ballot box with an AccuVote-OS installed in the ballot
box lid. If you knock the lift arm free the lid will drop on to you with the weight of both the lid and
the AccuVote-OS
.
1) Unlock the top lid of the ballot box.
2) Open the lid and prop it up on the lift arm by inserting the end of the arm into the notch in the
lid of the ballot box.
3) Lower the deflector into the ballot box and orient it with the pivot pin toward the front of the
ballot box.
4) Tilt the deflector so that the motor coupler is slightly raised above the motor shaft at the back of
the ballot box.
5) Insert the pivot pin into the pivot socket at the front of the ballot box.
6) Press the deflector towards the front of the ballot box until the motor coupler clears the end of
the motor shaft at the back of the ballot box.