3.4
Accessing the Rear Service Display
The rear service display is located on the upper chassis rear door (see
Figure 2-18). The rear service display can be used to perform certain maintenance
procedures. Perform the following steps to access the rear service display.
NOTE
For information about operating the rear service display to
perform specific maintenance procedures, refer to
Agilis 91x XV
Maintenance Manual
(TP-820744-001I) or the documentation
for your terminal control software.
1. Open the upper chassis rear door (refer to Section 3.2.1).
2. Pull down the rear service display release latch to free the display from its
closed position (see Figure 3-3).
3. Using the handle, turn the rear service display 180° counterclockwise
(one direction only). See Figure 3-5.
The rear service display is in operation position.
4. After the terminal maintenance is completed, swing the rear service
display to its closed position. Make sure the spring-loaded release latch
is securely latched.
NOTE
The upper chassis rear door will not close properly
unless the rear service display is returned to its closed
position.
5. Close the upper chassis rear door (refer to Section 3.2.2).
3-10
Copyright ©Diebold, Incorporated (7/2015, 3/2017) - All Rights Reserved
Copyright ©Diebold Nixdorf (2020) - All Rights Reserved
TP-821810-001C