MXS-9100 Optical Switch Rackmount Operation Manual
91592 Rev. A2
June 21, 2019
16
8. If the device does not have an IP Address you can give it one by clicking the Assign
IP
… button. See the Manual (Chapter 3) on the CD drive for more details if needed.
NOTE
: Once the Perle Device Server has an IP, it can be configured. The default serial
configuration is set at the factory and should not be changed. The DeviceManager program
should normally be used only to find and set the IP address of the MXS-9100. Changing the
serial configuration may cause communication problems.
Communicating With The MXS-9100
After the IP address has been assigned, you can open a TCP/IP connection with the MXS-
9100 over the network. To start sending and receiving commands, initialize a connection
with the MXS-9100 using the IP address and port 10001. A terminal program can be used to
verify the connection and send commands manually.
