Dickey-John Control Point, Руководство оператора

Страница: 15 / 109

OPERATOR’S MANUAL
Control Point
®
11001-1489-201702 Rev B
10 / SYSTEM INSTALLATION
CONSOLE PLACEMENT
The Console mounts inside the cab on any surface permitting easy
readability of the display without obstructing the operator’s view to the road
while driving (See Figure 3). Be sure the opposite side of the mounting
surface chosen has clearance for installing and tightening the mounting
bolts. The combination mounting plate positions the Switch Module to the
left of the Console.
U-BRACKET MOUNTING
1. Place the U-bracket in the exact location for mounting and mark both
drill holes with a pencil or scribe. If the Console is being mounted on
the dash, move and secure wiring and other obstructions located
beneath the dash.
2. Drill two 9/32 inch holes.
3. Position the U-bracket in place on the mounting surface and insert the
two 1 inch bolts.
4. Install the lock washers and nuts and tighten them.
CONSOLE AND SWITCH MODULE INSTALLATION
1. Install the Console onto the mounting plate using three 3/4 inch bolts
and lock washers.
2. When using the combination mounting plate, install the Switch Module
onto the mounting plate using three plastite screws.
3. Two sets of holes exist in the mounting plate to allow for optional
spacing between the Switch Module and Console. If only the Console
mounting plate is used, install the Switch Module at the desired
location. If placed on the vehicle seat, it must be secured in a suitable
manner (possibly using Velcro™ strips) to ensure the control settings
are not accidently changed or activated.