ENGLISH
19
Do not check the batteries by sparking.
The batteries give off flammable fumes. Put out all fires and hot embers before
checking or topping up the batteries.
Perform the operations described above in a ventilated room.
To avoid permanent damage to the batteries, do not run them down completely.
Remember that when the battery voltage displayed drops to about 29V, the batteries
must be charged.
8.1.
Charging procedure
•
connect the battery charger connector to the battery wiring connector;
IMPORTANT
In the case of gel batteries, use a charger specific for gel batteries only.
•
Charge the batteries as described in the battery charger manual;
•
at the end of charging, disconnect the connectors;
9.
MAINTENANCE INSTRUCTIONS
!
DANGER
Never perform any maintenance operations without first disconnecting the
batteries.
Maintenance on the electrical circuit and all other operations not explicitly
described in this manual must be performed by specialised personnel only, in
compliance with current safety legislation and as described in the maintenance
manual.
!
DANGER
The tank assembly (CT 230) MUST ALWAYS BE lowered/raised using the handles
incorporated in the tank (fig. C, ref. 3). Danger of crushing the limbs.
!
DANGER
When the tank assembly (CT230) is raised, the gas spring on the left side of the
machine (fig. T) must be locked in place by turning the green ring to the closed
padlock position to prevent the tanks from closing accidentally.
!
DANGER
The tank assembly (CT 160 – CT 230) MUST ALWAYS BE lowered/raised with the
tanks empty.
!
DANGER
When the tank assembly (CT230) is raised, the gas spring on the left side of the
machine (fig. T) must be locked in place by turning the green ring to the closed
padlock position to prevent the tanks from closing accidentally.
9.1.
Maintenance - General rules
Performing regular maintenance according to the Manufacturer's instructions improves
performance and extends the working life of the machine.
